QuikLift Shear Bars The QuikLiftShear Bar is used to increase the shear capacity of the Erection Anchor in thin panels. The Shear Bar fits over the anchor at the cutout and is secured tightly against the anchor. Proper installation allows the Shear Bar to transfer the shear loads deeper into the concrete to prevent spalling. Standard finish is hot-dipped galvanized.
L D H 3/4" Clear Min. Bottom of Face Erection Anchor Wire Tie Shear Bar to Anchor Shear Bar 3/4" Clear Min. Bottom of Face Equal Wire Tie Shear Bar to Anchor Shear Bar Top of Panel Bottom of Panel Erection Anchor
SHEAR BAR DATA
Part # Ton Ring Clutch System H - Height L - Length D - Diameter Weight (lbs) QL140G 2T-3T 2T-3T (QL001) 2-1/2" 14-3/4" 1/2" 0.98 QL141G 4T-6T 4T-6T (QL002) 3-5/16" 14-3/4" 1/2" 1.12 QL142G 8T-12T 8T-12T (QL003) 4-15/16" 14-3/4" 1/2" 1.29 Note: The unique shape and size of the QuikLift Shear Bars directly influences the performance. When a shear bar is required, the shear capacities listed in this manual rely on the QuikLift Shear Bars being used. Any other shape, material or strength bar may not perform properly, reducing shear capacities dramatically. Tension Bars provide a simple and economical method to increase tension capacity. (See Tension Bar Selection Chart) End View Side View 02/2022 800.332.7090 email@example.com alpsupply.com 44
QUIKLIFT SYSTEMPrevious Page